It holds just fine, it’s when it’s trying to go onto the next layer it goes up and immediately back down.
this is only happening on the gcode from ultimaker cura, I tried updating but it did work.
I can email you the video of it
Edited by anadskman
Recommended Posts
GregValiant 1,342
The gcode tells it where to go and if it isn't going there, then it's likely the printer.
Check the set screws in the coupler between the Z motor and the Z lead screw. They need to be snug.
After checking, use the LCD control and Auto-Home the printer. Next, use the LCD and move the Z 25 or 30mm up and see if it goes there and stays there.
Link to post
Share on other sites