Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

Ultimaker 2 over extrusion

Recommended Posts

so when i print with my um2 it seems to slow down momentarily then spew out more plastic than normal.it causes bulges and unevenness any tip? also the plastic beads up and looks like little drip marks instead of one solid line. the extruder is not clicking or skipping.


Share this post

Link to post
Share on other sites

the drip in stead of a 'noodle' can often be either the start of a blockage and/or a dirty end of nozzle - I always give mine a wipe when it is hot and then run a bit through - sometimes the noodles shoots off sideways so I wipe it a bit more until I get a nice straight down noodle.

warning - nozzle is hot :)

always worth doing the gr5 nuclear clean!



Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  


Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!