Printed my head in colorFabb Bronze Filament

[barnacules 0]

I 3D printed my own head in colorFabb Bronzefill material and it turned out amazing. I can't wait to finish the polishing on it and have it look like real bronze.

 

 

[daveholbrook 0]

Looks amazing! What were all of the settings you used? I've got an UM2 and am having real problems with a successful print. I'm also trying to print similar type face scans as yours.

Also, how did you get your scan? It's really high quality?

Dave

[gr5 2,230]

It's not a scan. It's an artists representation. One with talent.

 

[daveholbrook 0]

Wow, certainly one with talent. Looks amazingly detailed.

[jameshs 42]

polishing your head on youtube - this I have to see - eeeeuuugh!

James

 

[skint 62]

LOL james.... that`s just wrong!

Great vid Barnacules

 

[LePaul 331]

I looked on their website and didn't see anything besides 1.75 offered...is that what you used or did the have 2.85/3.0 available previously?

 

[barnacules 0]

The settings used were 0.16mm layer heights at 50mm/sec at 260C hot end and 60C bed and it printed out this way.

 

[ahoeben 1,987]

260C for bronzefill, are you sure? I print (and copperfill) at 205C-210C (which is much closer to what ColorFabb recommends)

 

[kerry 0]

I wondered the same thing. 260C seem very high considering what is recommended. I'd also worry about the bronzefill conducting so much heat to the teflon.