Hoi Arjan,
Did you tune the PID or not. SInce the mass of the warm part is much lower the PID needs some tuning. I don't know how I did it last time but I see there is a gcode command for it like M303 see
http://reprap.org/wiki/G-code#M303:_Run_PID_tuning
Run this from Pronterface and you get the values back in the terminal output.
My values are Kp=18.79 Ki=1.34 Kd=65.87 I build them into my marlin build.
Recommended Posts
rigs 735
I'm not sure but did you try with 40 watt E3d heater cartridge ?
I have this on my delta and work fine
Another way....PID tuning...Fan cooling...high flow rate....
Link to post
Share on other sites