hiya,
I can't find the app either. I went through the webpage too but no luck that way either. has it been dropped?
hiya,
I can't find the app either. I went through the webpage too but no luck that way either. has it been dropped?
No matter. It hasn't worked properly on my Samsung S8 for months anyway. When I connect to it I can see the camera view of the build plate with a message saying Already authorized, but when I touch the Connect to this Ultimaker 3, I get "The printer is not connected, make sure the device and the printer are connected to the same network, blah, blah, blah, please try again".
I've posted requests for a fix several times, but never received any sort of positive response.
Seems it's been abandoned . . . So sad.:(
@Nicolinux please save our app.... and make it better
The app should return back in the store. Probably the same app though. I understand there was an issue with the apple store, but it has been resolved now. Should be a little time before everything is back in order
No matter. It hasn't worked properly on my Samsung S8 for months anyway. When I connect to it I can see the camera view of the build plate with a message saying Already authorized, but when I touch the Connect to this Ultimaker 3, I get "The printer is not connected, make sure the device and the printer are connected to the same network, blah, blah, blah, please try again".
I've posted requests for a fix several times, but never received any sort of positive response.
Seems it's been abandoned . . . So sad.:(
If all you need is access to the camera than just use the below format for the IP of your machine and add:
Your_machine_ip:8080/?action=snapshot
or
Your_machine_ip:8080/?action=stream
You can read all about the configuration of the UM3 with the 6-day thread that David Braam hosted some time ago:
https://ultimaker.com/en/community/23254-inside-the-ultimaker-3-day-1-gcode
No matter. It hasn't worked properly on my Samsung S8 for months anyway. When I connect to it I can see the camera view of the build plate with a message saying Already authorized, but when I touch the Connect to this Ultimaker 3, I get "The printer is not connected, make sure the device and the printer are connected to the same network, blah, blah, blah, please try again".
I've posted requests for a fix several times, but never received any sort of positive response.
Seems it's been abandoned . . . So sad.:(
If all you need is access to the camera than just use the below format for the IP of your machine and add:
Your_machine_ip:8080/?action=snapshot
or
Your_machine_ip:8080/?action=stream
You can read all about the configuration of the UM3 with the 6-day thread that David Braam hosted some time ago:
https://ultimaker.com/en/community/23254-inside-the-ultimaker-3-day-1-gcode
I'm well aware of the "Your_machine_ip:8080/?action=stream" work around. The mobile app was originally designed to allow not just viewing, but also control, much like when viewing from within Cura during a print job.
Recommended Posts
Labern 775
The app seems to be forgotten about and has been version 1.0.1 since it first came out. It's disappointing as it could be so much better and a very handy tool.
So I can't answer your question but I think it's now dead sadly.
Link to post
Share on other sites