It's called "flow". If you set flow to 200% then that is the exact same thing as "material multiplier=2". It will increase the extrusion values by whatever you set the flow to. It will *not* create a "flow" gcode. It will just increase all the extrusion values by the flow value in cura.
Recommended Posts
lostinacrowd 0
This is something that I had to do in the Makerbot software as well since they didn't have any kind of "multiplier" way back when. Like you said it does the same thing, but it would be nice to keep the diameter set to the actual diameter and have a multiplier along side that.
Link to post
Share on other sites