UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Top Posters In This Topic
19
15
7
4
Popular Days
Dec 15
12
Dec 8
9
Dec 16
9
Dec 10
8
Top Posters In This Topic
MarkusP 19 posts
Smithy 15 posts
Muko 7 posts
Digibike 4 posts
Popular Days
Dec 15 2018
12 posts
Dec 8 2018
9 posts
Dec 16 2018
9 posts
Dec 10 2018
8 posts
Popular Posts
Smithy
Ja ABS ist etwas schwieriger in der Handhabung, geht aber mit Glas wunderbar wenn du zu ein paar Hilfsmitteln greifst. Du solltest unbedingt deinen Drucker abdecken, damit die warme Luft drinnen bleib
MarkusP
hallo Digibike , danke. Das waren jetzt gute Infos. Eine Türe habe ich seit gestern dran. Darf ich dir mal ein Teil hier einstellen? dann würde mich interessieren, wie du/ihr hier die Einstellung
danielfrei
Aufpassen bei deiner Türe. Wenn du ein Druckteil ganz nach vorne auf die Platte setzt, dein fährt dein Druckkopf normalerweise aus dem Gehäuse raus. Wenn da jetzt die Türe keine Einbuchtung hat, dann
Posted Images