Cura Slicer making some part of object grey

[imch 0]

Hello , 

I have been trying to slice an object for 3d printing. but few parts of objects are turned into grey area. even I put support everywhere. object is hollow from inside. does anyone know why its  happening here. and how can I resolve it. please help.

 

 

Edited February 29, 2020 by imch

[ahoeben 1,955]

16 hours ago, imch said:

does anyone know why its  happening here

 

The most likely cause of the first two is that the model is not manifold. Inspect it in X-Ray view, and it will probably show you parts in red. The models need to be fixed.

 

For the third example, I think the part is just too thin there.

[imch 0]

Yes just checked with X-rays view there is hole inside the object.  and for the third model you are right . walls are too thin .  How can I fix these issues ? can Cura fix these ?

 

I have another question : Does anyone know which format of sd card should be used for CR10s pro ? my sd card sometime shows files sometimes doesn't.  I want to reformat sc card . so does not know which format . I use MacBook Pro (Catalina )

[peggyb 171]

for scanned models `Meshmixer is a good program. There are lots of tutorials to help you. Thin models can easily be checked under 'Analysis' -> Thickness. Set your preferred thickness and it will show all the thin spots. It is also great for repairing.

[imch 0]

 Thank you for your tip peggyb . I fixed that with Meshmixer . it helped .