Must have Ultimaker mods for nubs?

[aviphysics 9]

Hey all,

I am hoping to get some suggestions for the most helpful mods to implement on a new Ultimaker Original.

Please share some of your Ultiwisdom, if you would be so kind.

Thanks,

Avi

 

[gr5 2,196]

Get wider blue tape. And this:

http://www.thingiverse.com/thing:46157

 

That's it. Don't get a heated bed. Don't print feet. Don't change the fan shroud (especially that!) as you are likely to make it worse. Do fix the electronics fan if it is noisy.

 

[IRobertI 521]

I think my first mod was this one and I don't regret it even a little: http://www.thingiverse.com/thing:11033

 

[aviphysics 9]

Get wider blue tape. And this:

http://www.thingiverse.com/thing:46157

 

That's it. Don't get a heated bed. Don't print feet. Don't change the fan shroud (especially that!) as you are likely to make it worse. Do fix the electronics fan if it is noisy.

I saw a fan shroud mod that looked very similar to the UIti2 fan shroud, so I was considering trying that.

Are printed feet bad or just not helpful?

 

[illuminarti 18]

I printed feet for mine (and then added rubber bumpers to those), and found that it made the printer a lot more stable and a lot quieter.

Take a look at http://www.thingiverse.com/illuminarti/collections/ultimaker-upgrades of UM upgrades. In addition to the extruder clip that George recommended above, I also found the short-belt tensioner, wave belt tensioners, and parametric end caps to be very useful. And the quiet extruder housing works pretty well for me too.

 

[IRobertI 521]

I've never seen the point in printing feet in solid plastic unless you want to raise the machine up for some reason. To cut down on vibrations going into the table and potentially amplifying the noise from the printer I simply put some rubber under it.

I think adding a second fan is more beneficial than a new fan shroud. I wouldn't worry about that in the very beginning of your journey though.

 

[LePaul 326]

There's a lot of really old stuff on Thingiverse for the Ultimaker that made me wonder what's relevant and what isn't (or perhaps outdated ?)