Strange and time consuming small print moves

[GoncaloLaranjeira 1]

Hi everyone!

 

I'm currently trying to print a model that after Slice shows some small weird print moves that I want to get rid of so it prints a bit faster.

 

I attached a photo so you can better understand what I am talking about 🙂

 

 

What can I do to change it or is it completely necessary?

 

Thanks! 

 

Edited December 1, 2020 by GoncaloLaranjeira

[CarloK 204]

What is your Cura version?

[GoncaloLaranjeira 1]

On 12/7/2020 at 11:58 AM, CarloK said:

What is your Cura version?

4.8.0

[CarloK 204]

I moved your question to the Cura section of this forum where it will get more attention.

I know of some problems in older Cura versions, but the problem you mention here is new to me.

[GregValiant 1,320]

If you would do a "File | Save Project" and save as a .3mf file, and then post it here, it would be helpful.

[Gero 54]

Would guess that at those points the wall is a bit thicker so that the inner wall line isn't enough to close the gaps.

 

Try to set the setting "Fill gaps between walls" to "nowhere" (in the shell tab).

 

Might be the fastest way to get what you want.