Help with print part of if dissapears when i put on supports

[johnboyman 0]

Hello. I am using fusion 360 and cura eveything works great. I just learned how to make supports and i am using them on my drone frame that i am trying to print off. On cura after I add some supports part of the inside of the four dougnut shapes on all four coners of my model vanish and there is a shadow remaining of where the shell should still be. I attached an image of this. Hope somone can figure out why this is happening. Thanks.

 

Edited December 13, 2020 by johnboyman

[Mari 36]

... don't understand what you mean, maybe you can put arrows on the image to point out what to look for!

 

If you don't mind you could share the Cura Project-file with us, so we can see what your settings are!

Edited December 13, 2020 by Mari

[johnboyman 0]

Here is the file an the image has an arrow pointing to where it should be a solid doughnut shape not hallow air. thanks

GA30_quadperfected.3mf

[Torgeir 248]

I'll think you'll need to make the whole model "joined all together" before you export from "Fusion 360" to Cura.

 

Thanks

Torgeir

[johnboyman 0]

Aww that's makes sense thanks for the advice.