Hey Sigi, thanks. Checked that too. But most of my filament seems to have an average diameter of 2.9mm. Usually I unroll the spool a bit, then measure the diameter in different places. I always measure only one side of the filament (not the one that is bent, because this would mess up the measurement).
Recommended Posts
Top Posters In This Topic
196
87
78
42
Popular Days
Jan 27
48
Jan 15
41
Jan 18
33
Jan 17
26
Top Posters In This Topic
Nicolinux 196 posts
gr5 87 posts
illuminarti 78 posts
braddock 42 posts
Popular Days
Jan 27 2014
48 posts
Jan 15 2014
41 posts
Jan 18 2014
33 posts
Jan 17 2014
26 posts
sigi 0
I didn't read through the complete thread, therefore it might have been already discussed:
Have you measured the diameter of the filament and checked if this fits to the material-setting in UM2.
A gap between these two might also cause underextrusion problems ...
Just thinking...
Link to post
Share on other sites