Can't get my settings right

[steve-rolo 0]

Hello all. I am very new to the 3D printing world, and I am having some problems with my prints. I have watched loads of videos, read some articles, and even talked to ChatGPT which has given me a good base knowledge of what some of the settings do and which one to change but I have got to the point where I no longer know what to change go get a cleaner print. I have got my prints to print okayish but they are not at a quality that I am happy with.

 

I do understand that it changes depending on what you are using and what you are printing so there is not one setting that fits all but I am hoping if I give my settings and show images then someone can give me some advice or just tell me what I have done wrong.

 

I am using a ANYCUBIC KOBRA NEO which I have checked is levelled correctly and I use painters’ tape to have that bonus adhesion. My PLA is OVERTURE PLA MATTE. I have attached screen shots of my code as well as Pictures of my prints.

AK_lizardfolk-warchief-sample-stl-32mm-lizardfolk-boss-32mm.3mf

Edited March 22 by steve-rolo

[Dustin 55]

I would recommend sharing a UltiMaker Cura project file, while the screenshots of settings help it does not really answer most the questions everyone will have trying to help you.

Articles
What is a Cura Project file: https://support.makerbot.com/s/article/1667337917554
How to save a Cura Project file: https://support.makerbot.com/s/article/1667411030205

[steve-rolo 0]

Thank you for your reply! I think I have done what you asked for.