Jump to content

Ultimaker 2 bed heating is too slow


disassembler

Recommended Posts

Posted · Ultimaker 2 bed heating is too slow

Hey everyone, i've used PLA since UM2 purchase, recently i decided to switch to ABS, suddenly i've noticed that UM2 starts to heat up the nozzle only when heating up of the bed is nearly done. However, heating of the bed up to 110 C takes like 15 minutes, it slows down greatly after reaching 70-75 C, is it normal? Also, I made a video of heating procces: https://www.youtube.com/watch?v=q5hPDojkv30

 

  • Link to post
    Share on other sites

    Posted · Ultimaker 2 bed heating is too slow

    That's about right. I have UMO with heated bed kit (and UM2) and did a test once on the UMO heated bed which is identical hardware. Also I did a print last week and getting from 100C to 110C seemed impossible - I think the room was too cold or too windy or something as it actually dropped a bit I think so printed at 105C instead.


    0:00 20C
    1:28 46C
    2:16 50C
    3:03 57C
    3:25 60C
    4:48 71C
    6:03 80C
    7:34 88C
    8:04 90C
    9:50 97C
    10:43 100C

    So for me it took almost 11 minutes to reach 100C and never really got to 110C unless I put a box over the top and plastic over the front.

     

  • Link to post
    Share on other sites

    Posted · Ultimaker 2 bed heating is too slow

    You could also get something for insulating underneath your HB... Like: http://reprap.me/heatbed/iso200.html

    It might give you the last few degrees... Or at least make you reach 100 degrees a bit faster

  • Link to post
    Share on other sites

    Posted · Ultimaker 2 bed heating is too slow

    Thanks, guys!

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...