Jump to content

Blizz

Dormant
  • Posts

    691
  • Joined

  • Last visited

  • Days Won

    1

Posts posted by Blizz

  1. According to the UM2s BoM it's the same type as the UM1 (D2110, of which I can't find much). However spare pieces for the UM1 feeder everywhere have the same spec, can anyone confirm:

     

    • Outside diameter: 7.5mm
    • Inside diameter: 5mm
    • String diameter: 1.2mm
    • Height: 20mm

     

  2. By a stupidity of my own doing I lost the spring that is part of the original feeder and despite all junk I have in house, spare springs are not part of that list.

    Can anyone point me to the specs of the spring and perhaps a location where I can purchase a replacement?

    Thanks! I really want to start printing again :O

     

  3. I did and for my UM2 it doesn't go so well..

    I usually print at 50mm/s so 0.2 shouldn't even come near the limit extrusion wise.

    At 0.15+ for me the fill lines stop touching.

    I don't know if this is some problem specific to my printer. According to Roberts guide this should be related to the short belts' tension but the provided solution hasn't helped me.

     

  4. Rick: Ik heb het ook al overwogen, maar als er op de meetings nu al naar je verwezen wordt als "Ben jij nou DIE BELG van op het forum?" dan denk ik dat het voor mij toch niet meer erger moet dan het al is :)

    Toch maar niet doen dus.

     

×
×
  • Create New...