Hi dim3nsioneer,
thanks for reply. Here what it looks like in legacy Cura x-ray view:
'Fix horrible' is set to 'Combine everything (Type A)' but I never set this - I hink this is the default?
But even if I disable it legacy Cura creates infill as expected - new Cura doesn't :-(
Edited by Guest
Recommended Posts
Dim3nsioneer 557
Hmm... the outer wall of that part also looks a bit thin in Cura 15.06.2. Did you have a 'fix horrible' setting activated in legacy Cura? What does the model look like in the x-ray view of legacy Cura? Any red there?
Link to post
Share on other sites