bob-hepple 59
Ok Chaps
Cleaned it all up and the same thing is happening throughout the philips screw hear is a picture
this time I have taken a video on iPhone how can I up load it the video, it clearly shows oozing from the screw unless I am blind and can't see something glaringly obvious I would like to share it with you.
The Block was cleaned I am using the original spring with 3dsolex PTFE and Steel coupler along with the i2K
Recommended Posts
bob-hepple 59
Hi Gr5 and Ultiarjan
I have left the pt100 alone it is stuck and I don't really need to remove it as I am cleaning up the block the biggest problem I had was making sure the temp probe stays put I replaced the Philips screw and tightened it heated up the block to 200 it became loose tightened new screw until you couldn't move it. I am using the i2k from 3dsolex, when I used the Korneels space I machines it down to a snug fit between the alloy plates I think this is where I'm wrong, and after my recent experience I tried backing off the the steel coupler but this goes way up and to much thread is showing so I think I need to remake it, so for now I have put the original spring back on which is way tighter than before (i2k) I have done this because time is of the essence I have work for the printer todo. Will post a picture later.
Gr5 yes I get exactly what you say about the temp probes I always thought that 175 was way below what others were using and when I tried the norm 200 it just was a mess
Thanks all will post picture later
Link to post
Share on other sites