DidierKlein 729
Yes @tinkergnome is right.
The screw that holds the bearing is probably pushing the yoke further from the printer plate, and that's why it's not in the good position.
Look here i made a tutorial to install it:
http://www.ideato3d.be/tutoriels/how-do-i-change-the-feeder-of-the-ultimaker-2/
Recommended Posts
tinkergnome 927
Looks like the screw of the ballbearing touches the wall. I think the "Yoke" is mounted in a wrong way? The screw head should facing you (if you look from behind the printer) - it's screwed directly into the plastic on the inner side. The screw hole is a bit smaller on one side - no nut needed. All other things are looking ok (to me) on the picture.
...but open the latch (and the arm) to feed material (by hand) - it's much easier.
BTW: consider to upload your photo here (to your album) - those picture services are a bit annoying...![:)](//content.invisioncic.com/ultimake/emoticons/5a33abdf6d109_1f60acopy.png)
Link to post
Share on other sites