If you switch to the basic mode, set it to normal, switch back to advanced and answer yes to the question to copy over the settings you'll get a good starting point.
You can also import settings from old gcode via the file menu (on my phone right now so can't check the exact name of the entry, but it should be obvious)
Recommended Posts
xisle 34
Which version of Cura are you using?
You can increase the "Bottom/Top Thickness" to a multiple of "Layer Height" that works out to more printed layers when closing the top.
For example, to get 6 layers on top with a layer height of 0.2, use bottom/top thickness of 1.2. If your layer height was 0.12 with the same bottom/top thickness of 1.2, you'd get 10 layers closing the top surface.
Link to post
Share on other sites