I don't know if my request was already said by someone, but like Slic3r It could be a great improvement to save differents parameters in profil link to the "Printer", the "Quality" and the "Filament".
For example save in a printer profil the informations of bed and head size, the e-step etc...
In the filament profil, the diameter, the flow, the fan on the first layer, the "normal" temp, etc...
And in Quality, The layer height, skin, speed, a factor in % to increase the "normal" temp according the speed, etc...
and let some parameters free like infill, support, raft, etc...
I think the concept to add some profile to make the complete profil is very good. We have an Ultimaker, but different filament from different manufacturer, we want different quality for different models. It's not easy when we switch to memorise all parameters.
For each print we will have only to select "Ultimaker"; "PLA3mm grey from Ultimaker"; "Best Quality" and let's go !
What do you think about that ?
Recommended Posts
3dcase 37
Hi There,
This morning I upgraded to Cura 13.06.2,
I Like the 'Project' part in it! easy to use, and to (like 12.xx) positon the print on the platform where you want it, Gives me less Blue tape changing.
Is it possible to put the 'Print sequence' back in again? Infill/Perimeter/loops gave my a smoother outside, and less Spider webs because of the idle traveling.
Regards,
Kees
Link to post
Share on other sites