Think about it.....If someone was selling two cars, but one was a year older than the other but the newer one was broken and you really needed to drive, which one would you buy....?
Sorry, I don't care of your opinion: it isn't the opinion of most of us. I agree that sometimes coders might release apps in a hurry, but I guess it isn't the culprit of my issue. Btw, before you know if a version might give problems, one must try it, I repeat. And it is always better to stick to newer versions, instead of downgrading. And, btw again, nobody knows if the culprit is the new version or else. You are fighting against windmills...
Edited by Guest
Recommended Posts
Top Posters In This Topic
27
8
6
3
Popular Days
Nov 5
8
Nov 1
8
Nov 6
7
Nov 2
7
Top Posters In This Topic
BiaC 27 posts
cloakfiend 8 posts
stu_le_brew 6 posts
nallath 3 posts
Popular Days
Nov 5 2017
8 posts
Nov 1 2017
8 posts
Nov 6 2017
7 posts
Nov 2 2017
7 posts
Posted Images
stu_le_brew 42
Have you checked in Cura machine settings that you have the correct setting for the flavour of GCode for you printer ?
Link to post
Share on other sites