Attached is the heavily edited gcode file for a little square test coupon that I use for setting up things.
All routine moves have been edited out with '<snip>' comments.
The gcode file has been cut off after the z offset section.
Z offset was for 200 mm to make it obvious.
Hope that helps!
Recommended Posts
Top Posters In This Topic
24
11
7
6
Popular Days
Feb 1
10
Apr 17
9
Feb 2
8
Nov 4
7
Top Posters In This Topic
ahoeben 24 posts
jens3 11 posts
dxp 7 posts
Oliveros 6 posts
Popular Days
Feb 1 2018
10 posts
Apr 17 2018
9 posts
Feb 2 2018
8 posts
Nov 4 2019
7 posts
Popular Posts
ahoeben
By popular demand, I have created a plugin which adds a Z Offset setting to the custom print settings: https://github.com/fieldOfView/ZOffsetPlugin The easiest way to install this plugin i
ahoeben
I have just uploaded a new version of the plugin for testing: http://files.fieldofview.com/temp/ZOffsetPlugin.curaplugin The Z Offset is now applied to the first Z move in the first l
ahoeben
The "double setting" problem is fixed now: http://files.fieldofview.com/temp/ZOffsetPlugin.curaplugin I have submitted the plugin to be included in the Plugin Browser for Cura 3.2.
Posted Images
ahoeben 1,956
Can you upload (the first part) of the gcode file somewhere, so I can have a look?
Link to post
Share on other sites