UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'm not an expert on thin walls but maybe try setting Minimum Wall Flow to 50. And if that doesn't help @smartavionics understands this much better than me.
I'm not an expert on thin walls but maybe try setting Minimum Wall Flow to 50. And if that doesn't help @smartavionics understands this much better than me.
That does fix the behavior in the layer preview! I'lle make a test print somewhere this week, but suspect it will be fine. Thank you!
It seems to work from 15% up. Does that mean that the second pass was being printed at lower than 15% flow? In practice, the printer seemed to be pushing through the filament through at the same rate in both directions.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,243
I'm not an expert on thin walls but maybe try setting Minimum Wall Flow to 50. And if that doesn't help @smartavionics understands this much better than me.
Link to post
Share on other sites
Verne64 0
That does
That does fix the behavior in the layer preview! I'lle make a test print somewhere this week, but suspect it will be fine. Thank you!
It seems to work from 15% up. Does that mean that the second pass was being printed at lower than 15% flow? In practice, the printer seemed to be pushing through the filament through at the same rate in both directions.
Link to post
Share on other sites