Ok so i leave all the settings as I find them, select the thermistor and i am done? What about the ulticontroller I have, any other setting to set? (I see there is a hardware section)
I see it generates a hex file for you. So it means I don't have to manually compile it? But i can just use that one?
Recommended Posts
illuminarti 18
The robotfuzz builder will do everything for you, and produce the finished hex file. You just have to set up the configuration options. If I remember correctly, you can just pick the basic Ultimaker setup from the drop down, and then all you need to do is pick the correct temp sensor type for your heated bed.
Link to post
Share on other sites