UM3 hotels plastic spring retainer replacement

[Penrock1547 2]

I had a few of my UM3 hot ends pop the plastic retainer piece that retains the spring. Is there somewhere I can get a spare plastic spring retainer? The plastic part is broken and needs to be replaced. This is just the plastic part on top of the hot end. I could probably glue it back but I’d rather just get another and replace it. 
Thanks!

 

[IRobertI 520]

These are not available as spare parts from Ultimaker I'm afraid. If you ask your local reseller nicely they may have a broken printcore lying around that they could steal that part from for you though.

[glx 27]

The part is available in the GitHub repository of the Ultimaker 3, I’m on mobile currently so I can’t easily look for it. But you can download it and print it out of PC or CPE+ or something. 

[MariMakes 199]

I believe you can find it here.
https://github.com/Ultimaker/Ultimaker3

But please be careful with your material choice like @glx said.
You want it to withstand high temperatures because if it melt to your printer you have a ruined printhead. 
It might be worth asking for a scap part like @IRobertI suggested. 

[Enigma_M4 120]

Hi,

a printable version can be found on thingiverse:

https://www.thingiverse.com/thing:2742644

But the temperature warning from @MariMakes made me rethink using it.

Regards

[Penrock1547 2]

Thanks all, I appreciate that. Many thanks. That’s stinks, I was afraid there might not be a replacement. I have 8 extruders all from the same ultimaker reseller. These are the only two that have done this. I’ll check out the STL, but yes it makes me nervous using a printed part given the proximity to the hot end. I might get some CP and try it. I might glue a washer to the underside of the plastic part so the hex bolt has something to grab. Might be possible to print a small recessed cylinder and glue that to the plastic retainer as that is what appears to have broken away from the main plastic retainer. Essentially I just need to attach something to the retainer so the hex bolt can hold it in place. 

[Penrock1547 2]

Well here they are, printed out of TPLA. Turned out pretty good. Haven’t printed with them yet, but did check the temp with a heat gun near that area while the printer was running and it never got above about 70-80F so I think the TPLA will be fine. They fit nicely too, popped right in. I’ve got some PC coming for Christmas so I may do a few out of that too. Thanks again for the STL! Cheers!