Tglase 3mm.

[qmaker 29]

I just received a roll of t glase 3mm. from taulman3d actual measurement is 2.75-2.8

Has anyone used this, does anyone have any suggestions for printing temps? I can't seem to get it to the bed or blue tape.

Thanks for any help.

 

[anon4321 16]

There is temp recommendations from taulman. http://taulman3d.com/t-glase-features.html but they imply that a heated bed is needed.

 

[cyclone 0]

328 is really high. Is the UM able to handle that much heat?

 

[dreamworker 1]

O_O ehm Ultimaker2 declare this :

 

• Operation nozzle temperature: 180° - 260° C
  

 

[Dim3nsioneer 557]

It's a typo. Should be 238°C. You may check the taulman website...

 

[gr5 2,194]

So spend the $5 or 5 euros and get a piece of glass. Clamp it down with paper clip binders. heat it to 40C with a hairdryer and try it out as suggested.

 

[codemaven 0]

I print T-Glase at 240C on a heated bed at 50C with blue tape... It prints fairly well, but it's best if you print very slow with large (~0.2mm) layers.

Cheers,

Troy.

 

[qmaker 29]

Thanks, I ended up at 238 and 50 as suggested on blue tape and finally got things working well. I did slow my print speed down as well.

Sorry for the alarming 338 degrees typo.