Like I said previously, you're getting fixated on an arcane technical aspect of a solution instead of clearly stating the actual problem you are having and asking for help on how to solve it.
Also not clear if you're printing in Nylon or T-Glase (PET), which have different bed adhesion strategies.
Recommended Posts
yellowshark 153
OK the plot thickens. I went to my 14.01 laptop attached to the printer and loaded a cube and then multiplied it, multiple mode was print all at once. I went to tools and changed the mode to print one at a time, nothing happened confirming my point in the previous post that you have to set the mode before multiplying the object. Then I swapped from normal view to layer view and blow me it redrew the bed layout to print one at a time.
So I deleted them all, reloaded with mode print all at once and then changed the mode to print one at a time. I printed them and as expected they did not print one at a time, they printed all at once.
I then went back to Cura and to layer view, expecting them to be redrawn and nothing happened. Over the next 10-15 minutes I could not replicate the redraw.
Link to post
Share on other sites