zerspaner_gerd 383
Alright, there is definitely something wrong. I re-sliced the object and printed while I was at home. It printed three times fine and the fourth time I heard a rattling noise - like the head trying to move farther than it could and had the "outside area" error.
I blame the firmware
I think it can also be a faulty trigger the Endstop cause (loose connection, cable breakage). Did you perhaps a cable tweaked during the assembly of the new motor feeder a?
Recommended Posts
Top Posters In This Topic
112
33
29
29
Popular Days
Jan 1
13
Nov 23
11
Dec 31
9
Dec 30
8
Top Posters In This Topic
tinkergnome 112 posts
ultiarjan 33 posts
rigs 29 posts
gpb01 29 posts
Popular Days
Jan 1 2015
13 posts
Nov 23 2015
11 posts
Dec 31 2014
9 posts
Dec 30 2014
8 posts
Popular Posts
chiz
Yup, it's the first run wizard. Ok, I'll try it and let you know what happens. Thanks a lot! Update: You're right! I need to complete the first run wizard first. After installing cust
Posted Images
Nicolinux 288
Alright, there is definitely something wrong. I re-sliced the object and printed while I was at home. It printed three times fine and the fourth time I heard a rattling noise - like the head trying to move farther than it could and had the "outside area" error.
I blame the firmware![:p](//content.invisioncic.com/ultimake/emoticons/5a33abe3e5fc3_1f61bcopy.png)
Link to post
Share on other sites