I noticed when I switched to Cura 14.03 that the cylinder had a slight hourglass curvature inwards for the first half a centimetre but this corrected itself
That inward curve is something unrelated. You can read about it here (5th picture down on left column of pictures):
http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide
Recommended Posts
Top Posters In This Topic
27
15
13
10
Popular Days
Nov 4
17
Feb 4
13
Nov 3
9
Oct 14
7
Top Posters In This Topic
Dim3nsioneer 27 posts
gr5 15 posts
pm_dude 13 posts
3devos 10 posts
Popular Days
Nov 4 2014
17 posts
Feb 4 2015
13 posts
Nov 3 2014
9 posts
Oct 14 2014
7 posts
pm_dude 27
Its a good point. I can run a few test prints and show the difference with and without the door.
Link to post
Share on other sites