My design is coincidentally pretty similar to yours but it is a snap-fit design no screw or glue applied. I also add printable carbon-activated air filter to tone down the smell.
would you be willing to share your model/STL files for the snap-channel for the acrylic? Same for the design of the door channel and handle. I am leaning towards doing a similar design but I'm, at best, barely a novice when it comes to 3D design. Also, did you print the rounded white piece on the rear of your printer above the filament spool?
I'm looking to purchase some 6mm/ 1/4" acrylic/plexiglass from my local hardware store in the next couple days. Any help would be greatly appreciated!!
Recommended Posts
Dim3nsioneer 558
I'm currently printing Ninjaflex... at 225°C... B)
Link to post
Share on other sites