I already figured out a way of getting cura to only put its support material where i want it and thats saved me a lot of pointless cleanup on overhangs that didnt need support and would just waste time and filament.
have you done this with the current possibilities in cura 15.10?
Edited by Guest
Recommended Posts
cloakfiend 996
Just like remote printing, I also think dual colour printing is a waste of time at the moment as far as im concerned, and if you are savy with your 3d apps and illustrator then for simpler designs like lettering you can just make holes to slot the other colours in, ive done it many times, its not that difficult, just takes a few trial and errors.
An improvement in surface quality and a soultion to overhangs and poor support material distribution are far more important than dual extrusion.
I already figured out a way of getting cura to only put its support material where i want it and thats saved me a lot of pointless cleanup on overhangs that didnt need support and would just waste time and filament.
Edited by GuestLink to post
Share on other sites