Gigi

Error handling is the cornerstone of any programmer. So, no. Is not ok to cut power. PS. Also for manual leveling, an option for abort will be useful. If something is wrong during leveling, you have to do the procedure till the end.

I asked, because it seams maybe will have a ruby nozzle for Ultimaker 3 by Olsson.

Clicking are from Z axis. It is about active leveling ? It is trying to compensate ?

It should appear "Abort" option.

The build plate is taking too long to warm up. Message on the LCD when trying to print with PC (ultimaker). No way out. I had to stop the printer from power button.

Just another ideea

What layer height did you print ?

Profile PC from printer (3.6 firmware)(Ultimaker PC white) Draft 0.2 mm

Will ruby affect Active leveling ?

try 2.5 beta

Also with Nylon+PVA was round.

it supposed to be round. The top is flat Maybe Cura ? or the suport bended the printed part ? With PLA was round.

3.6 Problem was with a chassis of an railroad model locomotive 18 cm long. At one end printed part raised from buildplate.

It is about first few layers when printing. For example if the print will start rise from the bed. It did happened to me and i cancel the print saving 5 hours.

At this time, Palette would work with the Ultimaker 3 if it is modified to accept 1.75 mm filament. Also, please note that although the Ultimaker 3 is a dual extrusion print head, Palette will only print using the primary print head. That was the response from Pallete makers on my email regarding possibility of conecting my Ultimaker 3 to their device.

Ultimaker PC Cura 2.5 beta default profile 0.1 layer In Cura selected Print core AA material - Ultimaker - PC - White PC On printer - Material 1 - selected - PC. (Firmware 3.6) Smal ring 1.1mm thick Big Ring 2mm thick Seems that printer did not finish small ring accurate at the end. Printed with support - Material 1 ]

Not bad for draft print with nylon.

Ultimaker Transparent Nylon. Cura 2.5 draft 0.2 profile recommended . First attempt was with hairspray but after few layers the print was raising off the build plate on the extremity. Then i used the glue stick from my UM3 and everything is ok. Printing a box cover 11 x 6 x 5 cm.(wall 1.5mm) Bottom already printed.

Some lines of support will remain between PLA layers. 0.2 profile recommended 20% support

Ok. Purge at start is firmware or software ? Make the same routine for BB core as the one for AA core. That is like Achilles heel.

BB core (PVA) Before print purge. Make the bubble, lift off, wait, make a second bubble and go to print area. PLEASE, after making the first bubble and lift off don't wait anymore... go to print area. Model move on build plate. It seams that BB core don't know where the model is. Making support outside the model. ???? (0.1 profile, recommended settings) Tested not moved model. Something wrong with support on this profile. Some of the support printed outside model ???

Where is the new beta ?

I know is difficult, but a system that could move the build plate left or right will win a lot of build area. That will compensate the position of print cores.

Version: 2.5.0-BETA Platform: Windows-10-10.0.14393 Qt: 5.7.1 PyQt: 5.7.1 Exception: TypeError: unable to convert a C++ 'QVector3D' instance to a Python object It happened when item select on the buildplate (only if "Center camera when item is selected" is cecked) Hardware: Ultimaker 3 video card Quadro K620