10 minutes ago, Nicolinux said:Hi, it could be that the bed is not leveled correctly. Check out this guide:
https://ultimaker.com/en/resources/17083-bed-levelinghttps://ultimaker.com/en/resources/17083-bed-leveling
No the bed is perfectly leveled, I checked before I did this print after I cleaned the glass. It begin always in the same corner. I buyed the kit with the glass on the front of the printer to keep the warmt inside and avoid turbulence if somebody passes the printer. Should I use the glue ? I read that is only necessary when using ABS filament and not PLA. The first layers are perfect, then it begins to bend. The bed is set at 60 degrees celsius...
Thanks for your reply to my question.
Edited by Den door
Recommended Posts
Nicolinux 288
Hi, it could be that the bed is not leveled correctly. Check out this guide:
https://ultimaker.com/en/resources/17083-bed-levelinghttps://ultimaker.com/en/resources/17083-bed-leveling
Link to post
Share on other sites