Jump to content

empty


juha-lehtinen

Recommended Posts

Just to let you know, I merged your two threads and moved it to a more suitable category.

 

  • Link to post
    Share on other sites

    Sharing link is now edited, it should now work.

    You can view and download it also

     

  • Link to post
    Share on other sites

    Just a few thoughts:

    6A, not true.

    7A, no need to clean the plate unless it has become dirty really.

    5B, if the filament has started to grind, don't just push the filament through and keep on printing. Clean the knurled sleeve so that it can properly grip the filament again. It can also indicate that something is wrong such as feeder pressure.

    5BB, not sure I agree with this method. It seems a bit more complicated than it needs to be. I would rather just yank the material out completely, perform an "Atomic"/"Cold pull", re-insert the bowden and then try again.

    1C, again, if the filament is grinding you need to clean stuff out before continuing IMHO.

    1CC, if the print quality is bad, re-printing will likely create another bad print if you don't figure out and fix what caused the bad print.

    1D, hmm, where have I seen this image and text before? ;)

    2D, how will it damage the printer? Also, another section I recognize :p

    2D2, I would say you should use something smaller than 0.4mm or you increase the risk of damaging the nozzle. It's also important to be gentle as brass is quite soft.

    Bottom of page 13: You should probably remove the "#leaning" part of the URL so that it leads to the top of the page instead.

     

  • Link to post
    Share on other sites

    You declare its a simple manual for beginners, but the beginning could be rather confusing for some users.

    1A starts off with something that is not supplied with the printer and no description of what it is. I personally wouldn't use any sprays inside my printer as i wouldn't want any residue to get over everything, but that just my preference.

    It would be good for complete novices to understand if, why, when they need to use adhesives, How much is to much? and how to apply the tape?

    As with Roberts guides, pictures are always helpful. 7A would be a good example of this.

    Just remember, everyone has different backgrounds and skill base. so it has to be written in a way that everyone can understand.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...