Belts seem tight. My shell thickness was 1, which I changed to 1.2 as my nozzle is .4 and Cura did not like the non multiple. Don't think this was the issue as Simplify3D had exactly two shells and same problem.
I will try speeds but first wanted to try the outer - inner. I am running the latest Cura but did not see it as an option so am trying Simplify3D which does support that feature and also the zebra artifact.
What artifact indicates temperature to low? I try to extrude at the lowest possible temperature on my other printer but the U2 seems to run hotter? Is 210 in the ball park for PLA?
Thanks, another swing or two...
Will
Recommended Posts
neotko 1,417
On 15.04 you can print infill after shell. On expert mode advanced. For me that removed that effect.
Link to post
Share on other sites