8) which nuts?
9) filament from Colorfabb (i think is a good manufacturer).
Colorfabb is very good manufacturer.
If you have problem #8, which is rare, you can tell because the filament spirals through the feeder and there is a spiral pattern on the filament in the bowden tube. also if you look at the knurled feeder shaft it is tilted. To actually see the nut in question you have to remove the feeder motor and look underneath it. It is similar to having a pebble under an iron causing it to tilt a bit. I doubt this is your problem but check everything.
Recommended Posts
Top Posters In This Topic
45
26
25
15
Popular Days
Jul 4
17
Jul 15
15
Jul 11
14
Jul 6
13
Top Posters In This Topic
esteban-pacheco 45 posts
gr5 26 posts
neotko 25 posts
cloakfiend 15 posts
Popular Days
Jul 4 2015
17 posts
Jul 15 2015
15 posts
Jul 11 2015
14 posts
Jul 6 2015
13 posts
Posted Images
neotko 1,417
Ok just another wild idea. Check the extruder and make sure it's thight and clean it with a wire brush. I mean this metal part.
Link to post
Share on other sites