I would not use the adhesion sheet for something like PLA for a variety of reasons, but mostly because there are cheaper alternatives for that type of material.
I believe they were for materials like ABS, PC and things that tend to warp a bit off the plate.
But, that is a guess on my part as I have not gotten around to testing that out yet.
Fair point.
But I am still stuck with a print solidly adhered to a plate, and I would rather get the print off without destroying the sheet. This is my current dilemma.
I had the idea of putting the glass plate back in the Ulti3 and cranking up the heat until it seperates. The adhesion sheets can happily go up to 100'c.
Recommended Posts
kmanstudios 1,120
I would not use the adhesion sheet for something like PLA for a variety of reasons, but mostly because there are cheaper alternatives for that type of material.
I believe they were for materials like ABS, PC and things that tend to warp a bit off the plate.
But, that is a guess on my part as I have not gotten around to testing that out yet.
Link to post
Share on other sites