kmanstudios 1,120
When you say printing with USB, are you mentioning the USB cable or USB stick drive?
Just trying to understand.
I own S3D and have printed just fine using the flash drive. But even if you are using USB cable and trying to print using Cura as the 'messenger' the problem will not change.
I did try a quick upload of S3D gcode as you mentioned and it does choke. But, I also must say that the gcode did not look proper in the viewport either, so I am assuming a mismatch between gcode flavors as Cura sees it. And, I have seen the same mismatch going from Cura to S3D, so I am assuming it may need to be edited.
So, I own S3D, paid for and all, but use Cura consistently because I find it to be quite good at what I am slicing. So I would ask what it is that you do not like about Cura?
Edited by Guest
Recommended Posts
LePaul 331
Just to play devil's advocate...does the S3D gcode print fine via USB?
Link to post
Share on other sites