So far I have used glue stick for bed adhesion. I haven't yet worried about the aesthetics of the first layer. Instead, as I now needed to print fairly thin strips (the center is only 0.6mm thick), I used uniform layer height (0.075mm) right from the beginning.
As bed temperatures, I have used 40-60C. In general Flex PLA sticks to the bed really well. I have used warm water to remove the prints from the bed, other methods have proven to be either very time consuming or too violent for Flex PLA.
Recommended Posts
Top Posters In This Topic
14
11
9
8
Popular Days
Sep 8
8
May 6
8
May 7
6
Apr 9
6
Top Posters In This Topic
pm_dude 14 posts
profepaco 11 posts
rhymeandreason 9 posts
gr5 8 posts
Popular Days
Sep 8 2014
8 posts
May 6 2014
8 posts
May 7 2014
6 posts
Apr 9 2014
6 posts
netsrac 4
@3Poro:
What did you do for sticking the Flex PLA on the bed? What was your bed temperature and did you use and additional things like glue stick or blue tape?
Link to post
Share on other sites