Haven't seen it, but could be related to the race-condition bug. Does the GCode view not update or does nothing update?
And what if you change a setting? (should trigger a new slice)
If only opening the gcode, I have no visualization in any view.
If I open a new model, I see it in normal view, but I can do whatever I want - change parameters, move the model - no slice is started...
Re-installed it the 3rd time but without success...
Recommended Posts
Top Posters In This Topic
39
28
17
14
Popular Days
Feb 19
27
Feb 21
21
Feb 24
14
Feb 20
13
Top Posters In This Topic
Daid 39 posts
Dim3nsioneer 28 posts
drayson 17 posts
maartenw 14 posts
Popular Days
Feb 19 2014
27 posts
Feb 21 2014
21 posts
Feb 24 2014
14 posts
Feb 20 2014
13 posts
Dim3nsioneer 558
Sorry for the delay, I was off during lunchtime... -_-
Everything works fine on my notebook (Asus ) with the GCODE view. It even started from the bottom when the gcode was loaded. No ghosts, nothing off-normal...
If you have administrator privileges on that notebook, you may want to check if you can update the display drivers...
Link to post
Share on other sites