yeah its to hot. make sure the fans are on full. you will want to print quite cold and could try printing 2 at once.
its not really the best design.
What temps?
Layer height?
speed?
printing at default 210 c (i was using 230 c and i got problems. and 210 i see incomplete extrusion in the infill structure and curling edges.)
0.1mm
50mm/s
Recommended Posts
Labern 775
yeah its to hot. make sure the fans are on full. you will want to print quite cold and could try printing 2 at once.
its not really the best design.
What temps?
Layer height?
speed?
Link to post
Share on other sites