Then when I get home it's already done, and I can physically take it off the build plate.
Or even better; Modify the head so you can bump the object off the plate. Especially with a heated bed this should be possible. Just cool down the bed, and smash the head into the object to push it out of the printer.
Sounds like a good plug-in for cura.
Recommended Posts
nallath 1,123
Or even better; Modify the head so you can bump the object off the plate. Especially with a heated bed this should be possible. Just cool down the bed, and smash the head into the object to push it out of the printer.
Link to post
Share on other sites