Yes it's plug and play with the pt100 and heater. I'm about to do some test prints again myself but have not had a lot of succes with pla....
The only thing that could require a firmware change is if you use a headmount that's bigger the the stock mount, to avoid it from crashing into the sides. But this should not be needed.
Recommended Posts
Top Posters In This Topic
64
57
44
24
Popular Days
Jul 16
21
Jul 8
13
Jun 25
11
Apr 10
11
Top Posters In This Topic
jonnybischof 64 posts
anon4321 57 posts
nick-foley 44 posts
mgg942 24 posts
Popular Days
Jul 16 2014
21 posts
Jul 8 2014
13 posts
Jun 25 2014
11 posts
Apr 10 2013
11 posts
Posted Images
3DukeEngineering 2
Could someone possible shed some light on what's required to run the v6 on the Ultimaker 2 with regards to the heater please? I have just received my v6 with the PT100 heater block, I opted for the 24v kit which I believe operates at 40w, and I also ordered an additional heater 24v 25w heater cartridge as this was available as a spare part through e3d.
Will the 24v 25w heater make this a plug and play solution without any firmware changes?
Link to post
Share on other sites