Nicolinux, someone else mentioned this nut so I looked at my extruder motor on the inside of the machine and it is flush against the back panel. Please also do this - look straight down from above and make sure the motor is touching nicely.
Nicolinux, I hung out with Sander the last 4 days and he said that he thought your part was shipped out about a week ago. He will not be coherent until Tuesday so wait until then to contact him. I think your package must have been sent to the wrong address.
Recommended Posts
Top Posters In This Topic
196
87
78
42
Popular Days
Jan 27
48
Jan 15
41
Jan 18
33
Jan 17
26
Top Posters In This Topic
Nicolinux 196 posts
gr5 87 posts
illuminarti 78 posts
braddock 42 posts
Popular Days
Jan 27 2014
48 posts
Jan 15 2014
41 posts
Jan 18 2014
33 posts
Jan 17 2014
26 posts
Nicolinux 288
By the way. As a simple comparison. When I still had my Ultimaker Original, I printed the Twisted Gear Lamp (http://www.thingiverse.com/thing:31722) with the following settings - with zero underextrusion:
Filament volume: 8mm^3/s.
Link to post
Share on other sites