It's a ball of fluffy fluff!
I'm trying to print with flexible PLA, but it's hard. The layers don't stick very well to each other, and prints fail quite simple. It's also very easy for the extruder to dig into the filament (because it's so soft)
This print was tried at 220C, 15mm/s 0.1mm layers, 0.6mm lines. After removing the fluff, the print broke into pieces as not all layers where sticking properly.
I'm now trying the same GCode, but at 240C, and 12.5mm/s
Recommended Posts
Top Posters In This Topic
362
282
221
179
Popular Days
Jan 5
30
May 12
26
Jan 13
23
May 1
22
Top Posters In This Topic
ian 362 posts
cloakfiend 282 posts
skint 221 posts
SandervG 179 posts
Popular Days
Jan 5 2014
30 posts
May 12 2014
26 posts
Jan 13 2014
23 posts
May 1 2014
22 posts
Popular Posts
kmanstudios
Took me forever to do this. And it is still rougher than I would have liked. 3D concept rendering: Finished piece:
kmanstudios
I just finished this. It was a multi-part print for ease of painting. Some of it I am not sure what happened...but hey, it is purty....And, I am unanimous in that ? Test Render Parts
gr5
Bath interferometers. I have made about 20 of these for people who use them to test their telescope mirrors. They are amazingly accurate and can do better than a $40,000 Zygo PSI optical tester. Th
Posted Images
Daid 306
Link to post
Share on other sites