The Ultimaker 3's display is managed by a different kind of computer (Olimex instead of Atmel (Arduino)), so this firmware probably isn't suitable for Ultimaker 3's right?
Maybe this is something that could be clarified in the introduction topic?
What is the "Tinker-Firmware"?It's an alternative firmware for machines of the Ultimaker 2 series.
Think it's already clearly stated it's for the Ultimaker 2 series.
Recommended Posts
Top Posters In This Topic
112
33
29
29
Popular Days
Jan 1
13
Nov 23
11
Dec 31
9
Dec 30
8
Top Posters In This Topic
tinkergnome 112 posts
ultiarjan 33 posts
rigs 29 posts
gpb01 29 posts
Popular Days
Jan 1 2015
13 posts
Nov 23 2015
11 posts
Dec 31 2014
9 posts
Dec 30 2014
8 posts
Popular Posts
chiz
Yup, it's the first run wizard. Ok, I'll try it and let you know what happens. Thanks a lot! Update: You're right! I need to complete the first run wizard first. After installing cust
Posted Images
chuck-yanke 10
Tinkergnome, I want I am just a humble user and have updated my U2+ with your most recent firmware. It is amazing. I have so much more information and control over the printing process. I am sure this takes a lot of your time, I truly appreciate all your work. Thank you!
Link to post
Share on other sites
peteruithoven 4
The Ultimaker 3's display is managed by a different kind of computer (Olimex instead of Atmel (Arduino)), so this firmware probably isn't suitable for Ultimaker 3's right?
Maybe this is something that could be clarified in the introduction topic?
Link to post
Share on other sites