Does anybody have an accurate model of the bottom part of the print head?
I don't fancy removing a small notch or two from my origional part so would rather print a modified replacement.
How bad of an idea would it be to run all the wiring "outside" of the head? I am thinking of making a little guide part that hangs on the two rear thumb screws.
Our UM2E is a work machine, so I am hesitant to "hack" it too much.
I think I will try to queue up several "head" upgrades (Rear Fan Duct, Rear Cable Guide, Olsson Block, Side Fan Ducts), and do them all at once.
Recommended Posts
Top Posters In This Topic
9
7
6
6
Popular Days
Oct 15
7
Oct 26
5
Oct 24
4
Oct 27
4
Top Posters In This Topic
Jamezracer 9 posts
izzy 7 posts
eldrick 6 posts
Torgeir 6 posts
Popular Days
Oct 15 2015
7 posts
Oct 26 2015
5 posts
Oct 24 2015
4 posts
Oct 27 2015
4 posts
Posted Images
eldrick 65
I just put a dab of superglue on two of the corners to hold the fan to the duct.
Link to post
Share on other sites