1 hour ago, JonD said:What version do you use on your UM2GO?
I use the latest Tinkergnome firmware because I upgraded the printer with a heated bed. Works fine without problems. But the UM2GO is a small UM2 printer and there were a lot of changes to the UM2+, but I guess there are a lot of UM2+ printers with latest firmware or Tinkergnome firmware.
40 minutes ago, nallath said:It also has the Ulti-bus, which we will use in the future.
Ahh, is this the connector at the back beside the NFC connector?
Recommended Posts
Top Posters In This Topic
89
40
38
36
Popular Days
Apr 23
76
Apr 19
32
Nov 2
31
Apr 26
30
Top Posters In This Topic
kmanstudios 89 posts
SandervG 40 posts
Shadowman 38 posts
uncle_bob 36 posts
Popular Days
Apr 23 2018
76 posts
Apr 19 2018
32 posts
Nov 2 2018
31 posts
Apr 26 2018
30 posts
Popular Posts
Daid
Problem was that dilithium was very difficult with legislation, being an accidental space-time warp risk. So we removed that feature last second.
Daid
It's bigger. 330x245x315mm to be exact. And that volume can be used by BOTH nozzles. No more less volume for dual extrusion prints. It has a flow sensor, that works for jam detection as we
foehnsturm
As for the flow sensor. We (the Mark2 crowd ) almost finished development for an external flow sensor for the UM2+ including firmware integration. Mechanically it fits to the UM3, but connecting to e
Posted Images
nallath 1,124
It also has the Ulti-bus, which we will use in the future. Appart from that, it also has significantly improved stepper drivers (making it more silent and being more future proof).
Link to post
Share on other sites