neotko
If you don't mind me asking. What are the pros and cons to this upgrade? I found your files on Youmagine and was instantly intrigued. I keep looking at the kit trying to figure out what i'm missing. It tickles the tinker itch very much. If I am assuming properly this will allow better prints vs our original + print head. Just trying to figure out how.
Thanks for this tutorial and the files. It looks amazing!
Edited by Guest
Recommended Posts
neotko 1,417
Oh yeah is very important. It will clog & short the TFM life span (probably both things).
Just make a custom firmware with the /experimental version and click on the 2.1.4 board part. If this is confusing check the youmagine, I explained to someone how and where to go just yesterday.
Edited by GuestLink to post
Share on other sites