I tried an enlarged Raft. Did not try the Brim as it is seems so fragile compared to a Raft.
I use the Brim for PLA print as it is enough in that case and is easy to remove.
So when switching to ABS it was the first i tried.
I did however not enlarge it.
But. Considering the way the ABS came lose I don't think a wider Brim would had made any difference.
However, if it is the recommended solution i will of course try it.
I'm printing using the glue.
Recommended Posts
illuminarti 18
Have you tried using a wide brim to increase the surface area in contact with the bed, rather than a raft?
Also, are you coating the glass with anything to improve adhesion?
Link to post
Share on other sites